ERPNext Setup not completing on VM

Install / Update Setup
1

Hi,

I am trying to setup the ERPNext using the available Virtual Box file.
But I am running into an error, and the setup does not complete. Its gets stuck on the setting up page and does not load further.

Here are the error messages I observed on the console.

Frappe1.png1280×720 67.8 KB

Any help regarding this would be really helpful.

Thanks and regards
Ajit

2

increase the timeout using

bench config http_timeout <no of seconds>

example
bench config http_timeout 600

3

Hi Akshay,
Thanks for your suggestion.
I tried what you suggested, but the VM gave an error.
I am not able to copy the log of the error, but I have a screen shot of it, as shared below.

Frappe-2.PNG646×557 27.6 KB

Thanks and regards
Ajit

4

@ajit.jain1

Do you have latest ERPNext VM copy?

Since looking at the error that you have posted it feels like your sites folder is missing common_site_config.json file. In case, file is not present then you may have to create it by executing

  • bench setup config
5

Hi Shreyas,

Yes it is the latest version.

Frappe-3.PNG636×549 12.6 KB

Thanks and regards
Ajit

6

Also, here’s the screen shot of the command you suggested and the errors it gave @shreyasp

Frappe-4.PNG640×550 20.7 KB

Thanks and regards
Ajit

7

@ajit.jain1 did you issue the commands from the “frappe-bench” folder … just ensure that you use the command from that folder

8

@mehta_akshay

I made the changes according your suggestions, timeout to 600 and even to 900 and I got this error

Frappe-5.png1266×479 50.9 KB

Thanks and regards
Ajit

9

Hi,
Finally was able to setup the ERPNext.

I increased the timeout and added a couple of network adapters to the virtual machine.

Thanks a lot guys.

10

Please can u tell me what are you doing exactly and where i should add a network adapters …please can u take a picture of this solution…iam a begginer

11

@Zineb_Nidali
Please check below link