Hi,
May we know the operating environment , including memory and disk space available?
It may also help to say which instructions were followed to install Frappe.
Hello guys,
i have solved the disk space problem but now i am getting below error when run bench restart commad
Hello @smino,
I have done the command bench build but still same error on the bench restart` command
Can you provide the last few commands you ran?
cd /home/frappe/frappe-bench
bench setup socketio
bench setup supervisor
bench setup redis
sudo supervisorctl reload
bench build
This done also
- Manually created a file at
/etc/supervisor/conf.d/usingsudo nano /etc/supervisor/conf.d/frappe-bench.conf - Manually copied the contents of
frappe-bench/config/supervisor.confinto/etc/supervisor/conf.d/frappe-bench.conf - The do
sudo service supervisor restartto restart supervisor will all the required processes of frappe
Again, where is this hosted, how was it installed and how much RAM ?
What does supervisorctl status return?
Seee what journalctl -u supervisor.service --since 00:00 (or some other time value) reports
the output of : id to see what groups , and sudo apt install -s supervisor redis-server to make sure they are installed.
Review the installation procedure and make sure the system requirements have been met , karani’s page might be helpful.
@smino all things are updated as mentioned in karani’s page
sudo systemctl status redis
sudo systemctl status supervisor
ubuntu version
Python version
pip version
mariadb version
Node.js version
yarn version
Here’s some output from a working Ubuntu 22/python3.10 instance, note the id output and the commands are run without sudo.
Do bench setup requirements/redis/supervisor (no sudo) all complete without errors?
In the terminal type: id , and compare the groups to the ones in the id output in the dpaste.
Are you able to run systemctl commands without sudo?
Do bench setup requirements, bench setup redis and bench setup supervisor all complete without errors?
@smino
bench setup requirements
bench setup redis
bench setup supervisor
These commands ran successfully without sudo and errors.
If the bench restart command returns the same error, it suggests a permissions problem. I don’t know what instructions were followed to install , and I’m not sure Ubuntu 24/python12 are supported officially. There are other posts in the forum relating to those platforms. For example: Can I install ERPNext v15 on ubuntu 24?
If I can think of anything else to try I’ll post it here.