Socket is not working for development mode of frappe docker
How to enable it?
pull latest and try again
Rebuild the containers if using vs code
Not giving the socket error so I tried this tutorial but its not working
can you try that tutorial on non Docker bench and check if it works?
No I was never able to setup erpnext without docker as there always occurs an error on some point so I use docker
is it not possible to use socket in docker development?
I think the tutorial is not working on latest version.
Check how chat works if enabled on website from website settings.
ok let me check
Chat is not working on run time means socket must not be working
If I type it shows that other person is typing but message is not received unless I reload
I tried chat on /desk and it’s working without refresh.
with docker in development? But I have followed the exact steps of installation
see here I have to go back to see the message
when new bench is created it serves default site.
sites/common_site_config.jsonhas entry"serve_default_site": true,and also the filesites/currentsite.txtexists.for the bench to serve multiple sites it needs minimum configuration changes after bench init is complete
try to set serve_default_site: false and delete sites/currentsite.txt
Ok I will try this tomorrow, also if possible add these instructions in the readme also so that other don’t get confused. Thankyou for helping.
Pull latest image and rebuild containers
docker pull frappe/bench:latest
Also try doing normal bench start instead of attaching debugger and check if it works
execute following command and then remove currentsite.txt
bench config serve_default_site off
This has nothing to do with Docker socketio in development. Start a new thread
https://frappe.io/docs/user/en/bench/resources/bench-commands-cheatsheet#config